Gold Tip Traditional Classic Carbon Shafts Item Number: 67102X
$52.99 $52.99
Gold Tip Traditional Classic Carbon Shafts

Gold Tip Traditional Classic Carbon Shafts

Item Number: 67102X
Loading
$52.99 $52.99


 
In Stock

They're the perfect combination of beauty and versatility. Gold Tip Traditional Classic carbon shafts feature jaw dropping beauty with their unique footed-wood grain finish. The included stainless steel inserts allow you to up your FOC (Front of Center) weight while still accepting Gold Tip Weights. For those who want to use these shafts with a G or F Nock, they are compatible with Gold Tip Accu Bushings. You can also purchase Gold Tip Ballistic Collars to reinforce your Classic shafts.

The skinny .204" ID gives you better penetration, less wind drift, and closer center shot for easier tuning.

Accu-Tough Nocks installed. Inserts included. Available in spines of 600, 500, 400, and 340 in 6-packs or dozens. Please specify.

  • Deflections of 600, 500, 400, 340
  • Sold by dozen or 6-pack
  • Footed-wood grain finish
  • Accu-Tough Nock installed
  • Nocks are White - color subject to change without notice
Gold Tip Traditional Classic Carbon Shafting Specifics
Spine Point GPI Length Insert Nock Point
Collar
Nock
Collar
600 9/32" 9 32" 72 gr Accu-Tough -- --
500 9/32" 9.8 32" 74 gr Accu-Tough -- --
400 9/32" 11.4 32" 78 gr Accu-Tough -- --
340 9/32" 12.1 32" 80 gr Accu-Tough -- --
Straightness  ±.006"        Weight  ±2gr       


Click Here for Helpful Arrow Tips from Gold Tip

Services Available
Standard Fletch: Our experienced fletchers will 3-fletch your Gold Tip Traditional Classic Carbon Shafting with 5" shield left wing TrueFlight feathers. The cock feather will be traditional barred and the 2 hen feathers will be your choice of white, yellow, red, or fluorescent lime (same color for all arrows). Hen feather color can be requested and will be fletched on a CLEAR cap wrap. No substitutions. Allow 4-7 additional business days for your order to be processed.

Cut Shafts to Length:  Have your carbon shafts cut to length. The length is measured from the valley of the nock to the back of the point. Minimum length is 27½".

Install Inserts:  Choose this option to have our experts install your Point Inserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.

If you prefer to customize your shaft with additional options, please use our Arrow Builder

See Printable Shaft Selection Chart PDF