Gold Tip Kinetic Pierce Carbon Shafts Item Number: 67093X
$124.99 $124.99
Gold Tip Kinetic Pierce Carbon Shafts

Gold Tip Kinetic Pierce Carbon Shafts

Item Number: 67093X
Loading
$124.99 $124.99


 
In Stock

The Gold Tip Kinetic Pierce carbon shafting features an Ultra-micro diameter that maximizes penetration and gives a decisive advantage in accuracy.

Gold Tip Kinetic Pierce shafts have been developed utilizing a new system with a half outsert instead of an insert. This allows the use of a standard 5/16" target point or broadhead with the benefit of deeper penetration from the less friction applied as the smaller diameter goes through the larger hole. Pinpoint accuracy is easier to achieve with the closer to centershot and minimized impact of wind drift due to ultra-micro diameter.

Reinforce the point end with the included ballistic collars for incredible durability on hard hitting impacts. Collars weigh approximately 23 grains each, and slide over the outserts, so you install them between outsert and point, so we cannot do it. The Kinetic Pierce are lightweight for shooting further distances with moderate draw weight bows, including recurve, longbow, or compound bow.

There has never been a better carbon arrow for the bowhunter or target archer. You will find the durability and performance of these Gold Tip arrows to be unbeatable. With the Gold Tip name, you know you can count on them for the toughness and performance that is expected.

Includes GTO nocks, half-out inserts, and ballistic collars.

Sold by the dozen. Available in 500, 400, 340, 300, and 250 spines. Please specify.

Gold Tip Kinetic Pierce Carbon Shafting Specifics
Spine Point GPI Length OutsertNock
500 5/16" 6.6 32" 20 gr GTO
400 5/16" 7.6 32" 20 gr GTO
340 5/16" 8.3 32" 20 gr GTO
300 5/16" 9.1 32" 20 gr GTO
250 5/16" 9.8 32" 20 gr GTO
Straightness      ±.006"        Weight    ±2 grains


Services Available
Cut Shafts to Length:  Have your carbon arrows cut to length. The length is measured from the throat of the nock to the back of the point. Minimum length is 27½".

Install Inserts:  Choose this option to have our experts install your Outserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.

If you prefer to customize your shaft with additional options, please use our Arrow Builder

See Printable Shaft Selection Chart PDF