
3Rivers Blue Jay Wood Arrows are stunning in appearance, exceptional in quality, and superior in performance!
Our Blue Jay Arrows are made from the finest 11/32" Port Orford Cedar (30-35# are 5/16"). They are hand-spined to be matched within 5 pounds and weight matched to 20 grain groups per set.
Each arrow has a special Black Walnut stain sealed with a durable polyurethane finish for longevity and a brilliant look shot after shot. The clear cap dip and cresting is done by hand for a "true" custom look and feel.
We then mount the arrows with blue Bohning Classic nocks and 3-fletched them with 5" Shield cut left wing feathers. A natural barred cock feather flanked by two blue Trueflight hen feathers. 30-35# and 35-40# feature 4" Shield cut left wing fletchings.
With all of that quality and attention to detail, 3Rivers Blue Jay Wood Arrows are certain to earn a place in your quiver.
Available in the following spines: 30-35, 35-40, 40-45, 45-50, 50-55, 55-60, 60-65 and 65-70#. Sold full length at approximately 32" and need to be cut and tapered, then points installed or broadheads mounted to be ready for shooting. Please remember, when having points or broadheads installed they must be purchased separately.
Sold by the 6-pack only.
PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.
Sold full length at approximately 32" and need to be cut and tapered, then points (or broadheads) mounted to be ready for shooting.
Points or broadheads must be purchased separately.
We offer a straightening service for wood arrows, but these arrows are not hand straightened before they leave the warehouse. Our arrows are hand-spined because we feel that is the key to good arrow flight.
PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.
Services Available
Cut and Taper Arrows to Length: Have your wood arrows cut to length and a 5° point taper. The length is measured from the valley (throat) of the nock to the back of the point taper. Minimum length is 26".
Mount Field Points: We install field points on your arrows. Points sold separately. Required the Cut and Taper service first. We use a heat reversible glue to mount points, so they may be changed later if you choose.











