Yumi Carbon Shafts Item Number: 6357X
$59.99 $59.99
Yumi Carbon Shafts

Yumi Carbon Shafts

Item Number: 6357X
Loading
$59.99 $59.99


 
In Stock

With a finish resembling lacquered bamboo, these carbon shafts are inspired by the war arrow of Japan's past - you almost have to touch it to know it's not real bamboo. The traditional name, So Ya Fushikage (war arrow with darkened nodes), refers to the shaded areas around the nodes in the bamboo, a pattern captured in the finish.

These elegant, super thin shafts have Yumi press-in nocks and nock collars pre-installed, and come with .159" diameter outsert (adds 1" to the length of the shaft, weighs approximately 49 grains), which allow them to use any standard screw-in 5/16" point or broadhead.

Note: Cut length is measured from end of the shaft to the valley of the nock. So Shafts ordered at 30" will be cut at 30" and with the outsert installed they will be 31" finished overall length to allow outsert clearance.

Yumi Shafting Specifics

Spine Point GPI Insert Outer Diameter Inner Diameter Length (does not include outsert) Point Collar
Nock Collar

300"

5/16"

11.4

49 gr

.253"

.165"

32"

N/A

N/A

400"

5/16"

10.5

49 gr

.243"

.165"

32"

N/A

N/A

500"

5/16"

9.3

49 gr

.236"

.165"

32"

N/A

N/A

600"

5/16"

7.8

49 gr

.228"

.165"

32"

N/A

N/A

Straightness .003" Weight N/A


Services Available
Standard Fletch: Our experienced fletchers will 3-fletch your Yumi shafts with 5" shield left wing TrueFlight feathers. The cock feather will be traditional barred and the two hen feathers will be your choice of white, yellow, red, or fluorescent lime (same color for all arrows). Hen feather color can be requested and will be fletched on a CLEAR cap wrap. No substitutions. Allow 4-7 additional business days for your order to be processed.

Cut Shafts to Length: Have your carbon arrows cut to length. The length is measured from the valley of the nock to the back of the point. Minimum length is 27 ½".

Install Point Inserts: Choose this option to have our experts install your Point Inserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.

If you prefer to customize your shaft with additional options, please use our Arrow Builder

See Printable Shaft Selection Chart PDF

See 3Rivers Archery Weight Tubes