Arrow Dynamics Traditional Series Black carbon shafts are specially designed for traditional hunters. The patented parallel-to-taper design gives these carbon shafts the correct spine-to-weight combination to work with a wide variety of recurves and longbows. Tapered carbon arrows experience faster shot recovery and less wind drag for improved accuracy. Expect to see deeper penetration over parallel shafts of equal diameter. The black (even includes grain run out) non-glare durable finish that will not wear off or fuse into targets. Use 11/32" field points and broadheads.
Sold by the dozen and 6-pack, full length. Bohning A nocks (or Easton X nock) installed, inserts included, but not installed.
Arrow Dynamics Traditional Black Carbon Shafting Specifics
|Spine||Point||Total Shaft Weight||GPI||Length||Insert||Nock||Point |
55 - 70# @ 28"
|11/32"||350gr||10.8||32"||26gr||Bohning A Nock/Easton X Nock||J||--|
|Traditional Lite |
35 - 55# @ 28"
|11/32"||275gr||8.4||32"||26gr||Bohning A Nock/Easton X Nock||I||--|
|Traditional XLite |
30 - 45# @ 28"
|11/32"||250gr||7.8||32"||26gr||Bohning A Nock/Easton X Nock||I||--|
|Straightness ±.006" Weight ± 7 gr|
PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.
Standard Fletch: Our experienced fletchers will 3-fletch your Arrow Dynamics Traditional Series Black Carbon Shafting with 5" shield left wing TrueFlight feathers. The cock feather will be traditional barred and the 2 hen feathers will be your choice of white, yellow, red, or fluorescent lime (same color for all arrows). Hen feather color can be requested and will be fletched on a CLEAR cap wrap. No substitutions. Allow 4-7 additional business days for your order to be processed.
Cut Shafts to Length: Have your carbon arrows cut to length. The length is measured from the valley of the nock to the back of the point. Minimum length is 27 ½".
Install Point Inserts: Choose this option to have our experts install your point inserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.
If you prefer to customize your shaft with additional options, please use our Arrow Builder
Glue-In/Glue-On Broadhead Adapters
Brass Arrow Point Inserts
Arrow Nock Adapters
Uni-Bushings for Arrow Nocks
Arrow Dynamics Press-In Arrow Nocks