Easton ST Epic N-Fused Black Carbon Arrow Shafts, dozen Item Number: 6752-3X
$89.99 $44.99
Made in the US
Easton ST Epic N-Fused Black Carbon Arrow Shafts, dozen

Easton ST Epic N-Fused Black Carbon Arrow Shafts, dozen

Item Number: 6752-3X
Loading
$89.99 $44.99
Made in the US


 
In Stock

Imagine if you could design and create the perfect carbon arrow shaft! Imagine no more! Easton has done it for you with the Easton ST Epic® N-Fused™ Carbon Arrow Shaft!

Built using Hybtonite® Nano Technology. The Hybtonite epoxy composite resin is infused to carbon nanotubes, giving the ST Epic unparalleled strength. The thicker wall (.231" ID) of this carbon shaft provides superior durability and deeper penetration.

These arrow shafts will accept Easton ST RPS Inserts and HP 50/75 Brass Inserts.

The low-profile diameter and precision HP inserts allow for less wind drift and pin-point precision. Features a micro-smooth black finish.

Translucent green H nocks installed, HP-3 inserts included. 500 spine measure 31¼" long, and the 600 spine measure 30¾" (end of shaft to valley of nock). Straightness ± .005" Weight ±2 grains. Recommended field point: 9/32". Available in 600 and 500 spine. Please specify. Sold by the dozen.

Easton ST Epic® N-Fused™ Carbon Shafting Specifics
Spine Point GPI Length Insert Nock Carbon
Collar

Nock
Collar
500 9/32" 8.0 31 ¼" 23gr H L --
600 9/32" 6.4 30 ¾" 23gr H L --
Straightness      ±.005"        Weight    ±2 grains       Length    ±½"


Services Available
Standard Fletch: Our experienced fletchers will 3-fletch your Easton ST Epic® N-Fused™ Carbon Arrow Shafts with 5" shield left wing TrueFlight feathers. The cock feather will be traditional barred and the 2 hen feathers will be your choice of white, yellow, red, or fluorescent lime (same color for all arrows). Hen feather color can be requested and will be fletched on a CLEAR cap wrap. No substitutions. Allow 4-7 additional business days for your order to be processed.

Cut Shafts to Length:  Have your carbon shafts cut to length. The length is measured from the valley of the nock to the back of the point. Minimum length is 27½".

Install Inserts:  Choose this option to have our experts install your Point Inserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.

If you prefer to customize your shaft with additional options, please use our Arrow Builder

See Printable Shaft Selection Chart PDF