Easton 6MM Full Metal Jacket™ Carbon Shafts

For a LIMITED TIME only, buy a dozen count and get a free Easton Arrow Tote when you use promo code EASTON19. Must be a dozen count or will not apply.

Reduced-diameter of 6 MM offers deeper penetration on big game, minimal wind drift for precision at further distances, and closer center shot for pinpoint accuracy.

The Full Metal Jacket of precision 7075 metal alloy wrapped around the incredibly strong carbon core for added penetration power over other ordinary carbon arrows. The two-tone Destroyer Gray finish offers easy target removal. Red color Easton H nocks. Easton ST Inserts.

• Deflections of 470, 390, and 320
• Sold by dozen and 6-pack
• Two-tone Destroyer Gray finish
• Carbon core with precision 7075 metal alloy jacket
• Red H Nock installed - color subject to change without notice
• Easton ST Inserts
• Outside Diameter of 9/32"
• Inside Diameter of 0.231"
li>Made in the USA by Easton

Additional Components
SKU: 6759X Easton HP Inserts	SKU: 6759-3 - Easton HP Break-off Inserts SKU: 0262 - Brass Inserts - Trad Only 600	SKU: 0150X UNI Bushings - Trad Only 600	SKU: 6720X - Lumenok - H SKU: 6725X - Nockturnal - H SKU: 0165X - Nock Out - H	SKU: 6751X Easton H Nocks

PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.

Services Available
Standard Fletch: Our experienced fletchers will 3-fletch your Easton 6MM Full Metal Jacket™ carbon shafting with 5" shield left wing TrueFlight feathers. The cock feather will be traditional barred and the two hen feathers will be your choice of white, yellow, red, or fluorescent lime (same color for all arrows). Hen feather color can be requested and will be fletched on a CLEAR cap wrap. No substitutions. Allow 4-7 additional business days for your order to be processed.

Cut Shafts to Length:  Have your carbon arrows cut to length. The length is measured from the throat of the nock to the back of the point. Minimum length is 27½".

Install Inserts:  Choose this option to have our experts install the included point inserts in your shafts. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to the stock length (as specified in the chart above). Please Note: We use epoxy style adhesives on all inserts and most points. Once they are installed, they are permanent.

If you prefer to customize your shaft with additional options, please use our Arrow Builder

See Printable Shaft Selection Chart PDF