3Rivers Emerald Hunter Arrows are stunning and unique, with handcrafted quality through-and-through.
We start with port orford cedar 11/32" parallel shafts (30-35# are 5/16"). They are grey bark stained, hand crested (in emerald, black, and gold), then sealed with gasket lacquer. The cap dip is natural to show off the beauty of the wood grain.
The Emerald Hunters are 3-fletched with two solid green and one barred green 5" shield cut left wing Trueflight feathers. Finished with a Bohning Classic pearl nock.
3Rivers Emerald Hunter Arrows are weight matched to groups of 20 grains.
Sold full length at approximately 32" and need to be cut and tapered, then points installed or broadheads mounted to be ready for shooting. Please remember, when having points or broadheads installed they must be purchased separately.
Sold by the 6-pack only.
Available in spines of 30-35, 35-40 ,40-45, 45-50, 50-55, 55-60, and 60-65.
Our arrows are hand-spined because we feel that is the key to good arrow flight.
Not sure which size to order? See our Arrow Spine Selection Chart.
PLEASE NOTE: Any service requested may delay shipment. Items with services applied are non-refundable.
Cut and Taper Arrows to Length: Have your wood arrows cut to length and a 5° point taper. The length is measured from the throat of the nock to the back of the point taper. Minimum length is 26".
Mount Field Points: Choose this option to have our experts install your Field Points on your arrows. Points are sold separately. Please Note: If you select this service without selecting the "Cut to Length" service, your shafts will be cut to even length (if any variance between arrows), and the point taper applied. Please Note: We use a heat reversible glue to mount field points, so they may be changed later if you choose.