So I picked one of these up to accompany my jig board.
Looking at the instructions it seems as though the 2 boards that connect the jig to the "spooler" are to be installed "upside down"?
is that correct? should the curved edge be underneath? The pilot holes for screws are countersunk in a way that that seems right, just want to clarify.
Also, the screws seem to not come out of the other side very far (maybe an 1/8 or a 1/4. that doesn't seem very deep to hold the jig to it, and feel like if it was knocked they may get ripped out. How far should they go in? Should I maybe counter-sink the connecting boards a bit deeper?