|
|
 |
Thunderhorn Two-Point 6-Arrow Bow Quiver |
|
|
Item Number: 6821
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Full Product Info |
|
Product Ratings & Reviews |
|
Ask A Question |
|
|
|
|
|
|
|
|
|
|
|
Q: Can you take it off once you attach it? Asked on 6/1/2012 by john Know the answer? Answer this question 1 answer A: Yes, you have to take the limb bolts out in order to get the quiver off. Answered on 6/2/2012 by Josh from 3Rivers Archery
Q: Does this work with the spirit riser with native/deerspace limbs? Asked on 6/1/2012 by john Know the answer? Answer this question 1 answer A: No you would have to use their side arm quiver available on their website Answered on 6/5/2012 by Dave from 3Rivers Archery
Q: Will this quiver also work with left-handed bows? Asked on 3/5/2011 by Anonymous Know the answer? Answer this question 2 answers A: Yes, it will work with left handed bows. Answered on 3/8/2011 by Justin from 3 Rivers Archery A: This quiver will also work for left handed takedown bows. All you will need is a hex/allen wrench and a knife, nail, or anything else to pull the foam out of the hood, in order to get the the screw. Answered on 5/12/2012 by AllenJ from VA & SoMD
Q: does this quiver hold carbon arrows? Asked on 2/12/2011 by Anonymous from Hilo, Hawaii Know the answer? Answer this question 1 answer A: Yes the it will take carbon shaft's. Answered on 2/15/2011 by Clint from 3Rivers Archery
Q: will this two-point quiver fit the sage no tools take down recurve? i heard there might be an issue whith the sage's limb bolt not bieng long enough?? Asked on 1/28/2011 by Rusty from marion ind. Know the answer? Answer this question 1 answer A: Yes, it should fit just fine. If the limb bolts are too short, you can always get a replacement set of bolts from most local hardware stores. Answered on 2/1/2011 by Anonymous
Q: Will this go on a Martin Jaguar takedown 50# recurve with no modifcations to either it or bow? Thanks Asked on 12/14/2010 by Jackcountyman from Texas Know the answer? Answer this question 1 answer A: I have not put it on a Martin Jaguar, but I do strongly believe that the Two Point bow quiver should fit on the recurve with no modifying needed. Answered on 12/30/2010 by Johnathan Karch from 3Rivers Archery
Q: How does this attach to the two brackets that are mounted under the limb bolt? and in your opinion is the asily removed once you are on stand? Thanks Asked on 9/22/2010 by Abram from Alabaster, Al Know the answer? Answer this question 1 answer A: The Two-Point bow quiver uses an "L" bracket that goes against the face of your takedown bow limb. Put your limb bolt and bezel on top of the "L" bracket - bolt goes through the hole and into the riser. Tighten firmly as you would normally do with the limb. As for removal when on stand the Two-Point is not a good choice as it requires you to take the arrows out of the quiver before removal. Answered on 9/27/2010 by Johnathan Karch from 3Rivers Archery
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
